Before adding your field boundaries to Carbon from your John Deere Operations Center, if there are any overlapping boundaries, use this step-by-step guide to edit them.

See the loop video below for a quick demo of this process or follow the 6 steps below.

Step 1: Log into MyJohnDeere:

Step 2: Navigate to Operation Center: Setup > Land:

Step 3: Search or select the field with the overlap.

Step 4: Click the boundary, then click again to make geometry points appear.

Step 5: You may see several geometry points on the overlapping side of the boundary. To remove the extra points, click on the white dots overlapping the neighboring field, they should turn black. Click the trash icon to remove them.

Step 6: Once you have a few dots left you can click and drag them to fit the accurate boundary until the field no longer overlaps with a neighboring field.

Did this answer your question?